Advertisement
Refer to the steps below should the UPS
fail to function correctly
Step 1: Is the AC Mains switch in the
"ON"position?
Step 2:Is the UPS plugged into the AC
power supply?
Step 3: Is the power supply within specified
unit values?
Step 4: Has the fuse gone in the mains
plug?
Step 5: Is the UPS overload?
Step 6: Is the battery flat or defective?
Description
Model
Capacity
Input
Voltage
Voltage Range
Output
Voltage Regulation
Transfer Time
Waveform
Battery
Type & Number
Charging time
Physical
Dimension (WxHxD, mm)
Net Weight (kg)
Packaging Dimension
(WxHxD,mm)
Gross Weight (kg)
Environment
Humidity
Noise level
Standards and Certifications
Safety Standard
EMC/Surge Standard
Mark
STEP2
STEP1
GR600/GR800
TROUBLESHOOTING
Situation
Problem / Possible Causes
Battery voltage is low.
No LEDs displayon the
Battery is defective.
frontpanel.
The UPS is not turned on.
Alarm beeps
continuouslywhen the
The UPS is overloaded.
Utilityis normal.
The UPS is overloaded.
UPS does not provide
expected backup time.
Battery voltage is too low.
Battery is defective.
The Utility is normalbut
Power cord is loose.
LED is flashing.
800LS
800VA/400W
12V/7Ah x 1
4.5
5
192321982010000
STEP1
STEP2
Charge the UPS at least 6 hours.
Replace the battery withthe same capacity.
Press the power switchagain to turn on the UPS.
Remove some loads/equipment first.The connected equipment
exceeds the
UPS specified 'capacity/load".
Remove some loads/equipment first.The connected equipment
exceeds the
UPS specified 'capacity/load".
Charge the UPS at least6 hours.
Replace the battery withthe same capacity.
Reconnect the power cordproperly.
Ablerex 800LS/1000LS SPECIFICATIONS
220/230/240VAC
160~290Vac
220Vac+/- 10%
2ms ~ 6ms Typical
Simulated Sine Wave
4-6 hours recover to 90% capacity
100 x 140 x 292
137 x 226 x 321
95% RH Maximum,Non-condensing
Less than 40 dB
EN62040-2
EN61000-3-2, EN61000-3-3
CE, RoHS, TISI
2
GR1200/GR1800/GR2000
Solution
1000LS
1000VA/600W
12V/9Ah x 1
5
5.5
Advertisement
