E Record Settings (Record); F Disk Settings (Disk); G Version Information (About) - Sanyo DSR-2108 Instruction Manual

Setup menu settings
E
Record settings (Record)
Sets the recording conditions while in network operations.
Recorded video is saved on the hard disk of the PC.
1 Record Condition
Select a recording mode using the radio button.
• Always:
Recording is performed when the recording button on
the operation panel is set to ON.
• Event:
When the recording button on the operation panel is set
to ON, recording is on standby and recording is
performed when specified events occur.
<Automatic recording settings (Auto Record)>
If the checkbox is checked, the recording button on the
operation panel is set to ON and video is automatically
recorded in the selected recording mode only after you
launch the DVR Utility 2000S the next time.
[Auto Record] settings become valid as soon as the unit
has been disconnected and reconnected.
2 Event
If [Record Condition] is set to "Event", set the following
conditions.
<Event types>
• Motion:
When this unit performs a MOTION recording the event
is also recorded on the PC.
• Alarm:
When an alarm signal is input into the external sensor
terminal situated on the back panel of this unit, the
event is recorded on the PC.
<Recording duration>
• Duration (Unit: seconds)
3 Channel
Specify the camera to be recorded using the checkbox.
Memo: Using "All" of the checkbox, the user can check or
uncheck all the cameras.
Click [OK] once the above settings are complete.
The content of the settings are confirmed and saved.
65
F
Disk settings (Disk)
Set the capacity and the drive of the PC where the recorded
video is saved.
1
2
3
1 Disk Space
Select the drive used for saving and input the allowable
capacity (MB).
2 Disk Full
Select the option once the capacity is exceeded using the
radio button.
• Replace oldest files:
Continues to record and overwrites the previously
recorded video starting with the oldest.
• Stop recording: Stops the recording.
Click [OK] once the above settings are complete.
The content of the settings are confirmed and saved.
G
Version information (About)
The version information of the currently used software can be
confirmed.
1
2