Pre-Operation Preparation; Screen Display - Sanyo DSR-2108 Instruction Manual

Pre-operation preparation

Screen display

Upon turning the power on, live video is displayed in the multi screen format.
• The screen display can be hidden except for the recording screen display. (P31)
b Example of multi-16 screen
1 2 34
:A
CH1 CH2
C
CH5 CH6
CH10
CH9
CH13 CH14
7 8
1 Operation display
: Displayed during live video sequencing.
: Displayed during alarm output.
: Displayed when the alarm output is set to DISABLE.
: Displayed during remote operation by PC.
2 Remote control display (P41)
:A
: Displays the remote control ID currently in
operation.
If no remote ID is set the message "A(all)" is
displayed.
3 Alarm input display
: Turns red during an alarm recording triggered by
motion or external alarm input (ALARM IN).
4 Security lock display
: Displayed when setting the security lock. (P28)
5 Hard disk used capacity display
Displays the amount of recording on the hard disk from
0-99%. When the disk is full, "99%" changes to "FULL".
When the recording setting is set to overwriting and the
hard disk is full, to the left of the capacity display lights
to indicate that the unit is in the overwriting mode.
5 6
2% 2009/05/03 09:04:54
CH3 CH4
CH7 CH8
CH11 CH12
CH15 CH16
b Example of single-screen
1 2 34
:A
6 Date and time display
This unit manages the recorded videos according to their
date and time. Make sure the correct date and time are set
in the CLOCK SET. (P9)
7 Camera channel display
Select display/hide channel in "OSD" in "LIVE settings".
(P31)
8 Recording display
Factory default settings start continuous recordings (C)
automatically once the power is turned on. Change the
recording mode using the menu settings. (P35)
C: Recording in the continuous mode (CONTINUOUS)
R: Recording in the real time mode (When pressing the
REC/STOP button)
M: Recording in the motion detection mode (MOTION)
A: Recording in the ALARM IN detection mode (ALARM)
• If a live video is disconnected, the message "VIDEO
LOSS" is displayed on the monitor.
• If a video signal is not connected to the video input
terminal, the message "NO VIDEO" is displayed on
the monitor.
5 6
2% 2009/05/03 09:04:54
CH1 C
7 8
8