Bcontinuous Recording; Cmotion Recording - Sanyo DSR-2108 Instruction Manual

Recording
B
CONTINUOUS recording
1
Recording starts automatically when this unit is
turned on.
"C" is displayed on the screen. The connected cameras
are simultaneously recorded.
The recording mode can be changed using
RECORDING under RECORD settings. Settings, such
as image quality, can also be set. (P35)
:A
CH1
CH3
2
To stop recording, select "RECORDING" under
RECORD settings using the control button ({|) and
select "DISABLE" using the control button (}~).
"C" disappears.
RECORD
RESOLUTION
CHANNEL
FRAME RATE
QUALITY
RECORDING
MOTION ZONE
MOTION SENSITIVITY
ALARM RECORDING
PRE RECORD
POST EVENT RECORD
AUDIO
TIMER SET
REAL-TIME REC SET
C
MOTION recording
A motion sensor can be set for each channel.
1
Adjusting the following settings using the control
button ({|}~).
• RESOLUTION
• CHANNEL
2
Select "RECORDING" using the control button
({|) and select "MOTION" using the control
button (}~).
17
2% 2009/05/03 09:04:54
C C CH2
C C
CH4
FULL
1 1
1 ips
NORMAL
CONTINUOUS
FULL ZONE
9
-- -- -- --
OFF
5 SECONDS
OFF
• FRAME RATE
• QUALITY
3
Select "MOTION ZONE" using the control button
({|) and select the "PARTIAL ZONE" using the
control button (}~), press the ENTER button.
The motion setting screen is displayed.
• PARTIAL ZONE
If "FULL ZONE" is selected, the motion setting screen is
not displayed. Only set the level of sensitivity for MOTION
SENSITIVITY.
RESOLUTION
CHANNEL
FRAME RATE
QUALITY
RECORDING
MOTION ZONE
MOTION SENSITIVITY
ALARM RECORDING
PRE RECORD
POST EVENT RECORD
AUDIO
TIMER SET
REAL-TIME REC SET
Detection
frame
4
Select the sensor detection position using the
control button ({|}~) and press the ENTER
button.
The frame set for the sensor detection is grainy.
Select a sensor detection position by repeating the
operation.
Once the setting of the event searched is complete,
press the EXIT/STOP button to return to the RECORD
screen.
5
Select "MOTION SENSITIVITY" using the control
button ({|) and select the level of sensitivity
using the control button (}~).
Selections: 1-9 (Low sensitivity)
6
Select "PRE RECORD" using the control button
({|) and select the pre recording as necessary
using the control button (}~).
7
Select "POST EVENT RECORD" using the control
button ({|) and select the recording time as
necessary using the control button (}~).
Selections: 2 - 30 SECONDS, 1 - 5 MINUTES,
10 MINUTES, 15 MINUTES
8
Press the EXIT/STOP button once operations are
complete.
Press the EXIT/STOP button repeatedly to return to the
live video.
• FULL ZONE
RECORD
FULL
C 1 1
1 ips
NORMAL
MOTION
PARTIAL ZONE
9
-- -- -- --
OFF
5 SECONDS
OFF