Pre-Operation Preparation; Screen Display - Sanyo DSR-2004 Instruction Manual

Digital video recorder
Hide thumbs Also See for DSR-2004:
Table of Contents

Advertisement

Pre-operation preparation

Screen display

After turning on the power, the message "INITIALIZING" is displayed. Next, the live videos are displayed on a quad-screen. The
screen display necessary to operations is displayed on the screen.
• The screen display can be hidden except for the recording screen display. (P25)
b Quad-screen
1 2
3
CH1
C
CH3
6
7
1 Operation display
: Displayed during live video sequencing.
: Displayed during alarm output.
: Displayed during remote operation by PC.
2 Remote control display (P32)
: This icon shows that remote operations are possible.
Depending on the remote ID number settings, this
icon may not be displayed and remote operations
may not be available.
3 Alarm input display
:
Blinks during motion or sensor alarm input. The mark is
one channel from the left.
4 Hard disk used capacity display
Displays the amount of recording on the hard disk from
0-99%. When the disk is full, "99%" changes to "FULL".
When the recording settings are set to overwrite and the
hard disk is full, 99% changes to
overwriting mode.
4
5
2%
2006/07/14 09:04:54
CH2
CH4
which represents
b Single-screen
1 2
3
5 Date and time display
This unit manages the recorded videos according to their
date and time. Make sure the correct date and time are set
in the menu setting. (P7)
6 Camera channel display
CH1/CH2/CH3/CH4
7 Recording display
Factory default settings start continuous recordings (C)
automatically once the power is turned on. Change the
recording mode using the menu settings. (P27)
C: Recording in the continuous mode (CONTINUOUS)
R: Recording in the real time mode (When pressing the
REC/STOP button)
M: Recording in the motion detection mode (BY EXT.
MOTION)
S: Recording in the sensor detection mode (BY SENSOR)
• If a live video is disconnected, the message "VIDEO
LOSS" is displayed on the monitor.
• If a video signal is not connected to the video input
terminal, the message "NO VIDEO" is displayed on
the monitor.
4
5
2%
2006/07/14 09:04:54
CH1
C
6
7
6

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dsr2004h80 - dvr

Table of Contents