Table of Contents
Advertisement
ABOUT THIS DOCUMENT
Purpose
This practice provides instruction for installing the Aerial Ultracab Cross-Connect Enclosures.
Reason for Reissue
Whenever this practice is reissued, the reason for reissue will be stated in this paragraph.
• Update the installation instructions and illustrations.
Information Not Provided in This Practice
Refer to other local practices or building codes as applicable for the correct methods, tools and materials to be
used in performing procedures not specifically described in this document.
If your enclosure is equipped with RLS terminal blocks, then refer to the following documents for specific
information on wire termination on RLS50 blocks:
•
641-202-002, RLS50 Self-Strip Block Description and Installation and
•
641-202-009, RLS50 Self-Strip Block Feed-Thru Half-Tap Activator Kit Description and Installation
NOTE!
The information contained in this practice is subject to change without notice and may not be
suitable for all applications.
Vertiv
| Aerial Ultracab Cross-Connect Enclosures (631-201-009) | Rev. F
13
Advertisement
Table of Contents
Need help?
Do you have a question about the Ultracab Cross-Connect and is the answer not in the manual?
Questions and answers