Brother ADS-1250W Online User's Manual page 159

Difficulties
The plastic card is
jammed.
The plastic card was not
fed.
Cannot scan to a USB
flash drive in Bus Power
Mode.
Cannot Scan to
Workflow from the
machine.
Software Difficulties
Difficulties
Cannot save the settings
in Remote Setup or Web
Based Management.
Cannot start Remote
Setup.
Cause
The power came on when the plastic
card was inserted in the machine.
The embossed card was inserted in
the Card Slot with the embossed side
down.
• The plastic card is not inserted
straight.
• The plastic card is not inserted
according to the guidelines.
The paper dust has accumulated on
the sensors.
A document was set on the ADF.
ADF Mode is selected in the Feed
Selector.
The embossed card was inserted in
the Card Slot with the embossed side
down.
Scan to USB is not supported when
using Bus Power Mode.
The Scan to Workflow settings are not
configured within Brother iPrint&Scan
®
(for Windows and Mac).
Cause
The machine is processing.
The machine is being configured from
the machine's Control Panel.
The machine is turned off.
The machine is not connected to your
computer.
An error is occurring.
The machine is scanning.
The machine is being configured from
the machine's Control Panel.
Because you pressed the
on the machine before saving the
Remote Setup settings, the machine
went into Sleep Mode.
A USB flash drive is inserted into the
machine.
Suggestions
Remove the plastic card. To prevent the card from
getting jammed again, do not leave the card
inserted in the machine.
Insert the embossed card, embossed side up, into
the Card Slot.
Insert the plastic card straight according to the
guidelines.
Clean the sensors.
See Related Information:Clean the Sensors.
Remove the document from the ADF.
See Related Information: Card Jam.
Slide the Feed Selector to the Plastic Card Mode
side.
Insert the embossed card, embossed side up, into
the Card Slot.
Connect your scanner to an AC power outlet, and
then try to scan.
Configure the settings using Brother iPrint&Scan
®
(for Windows and Mac).
See Related Information: Configure Scan to
Workflow Settings Using Brother iPrint&Scan.
Suggestions
Wait until the machine finishes processing, and
then try again.
Stop configuring the machine from the Control
Panel and use Remote Setup or Web Based
Management instead.
Turn on the machine, and then try again.
Connect the machine to your computer, and then
try again.
Clear all errors, check the status is Ready on
Remote Setup and then try again.
Wait until scanning has finished and try again.
Stop configuring the machine from the Control
Panel.
Access Remote Setup again and save the settings.
button
Remove the USB flash drive.
155