Supermicro SuperServer E300-9A-8CN8 User Manual page 54

SuperServer E300-9A-8CN8 User's Manual
 SATA1
SATA 1 Enable controller
This item enables or disables the onboard SATA controller supported by the processor. The
options are Enabled and Disabled.
SATA 1 ALPM
When this feature is set to Enabled, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link in a low power mode during extended periods
of I/O inactivity and will return the link to an active state when I/O activity resumes. The
options are Enabled and Disabled.
*If the feature above is set to Enabled, SATA 1 ALPM will be available for configuration:
SATA 1 ALPM
Use this feature to enable or disable Aggressive Link Power Management. The options are
Enabled and Disabled.
SATA 1 SGPIO/LED
Use this feature to select SATA SGPIO or SATA LED. The options are SATA SGPIO and
SATA LED.
 I-SATA0 ~ I-SATA2
This following information is displayed for each SATA drive entry:
•
Device Information
•
Device Size
Enable/disable port
Use this feature to disable or enable the SATA port number. The options are Enabled
and Disabled.
Spin up
When the value of an edge detect or the value of an image binary (pixel) of a device is
from 0 to 1, select Enabled to allow the PCH to start a COMRESET initialization sequence
on this device. The options are Enabled and Disabled.
54