Turning Your Phone On And Off - Sanyo M1 Owner's Manual

Turning Your Phone On and Off

Turning Your Phone On
To turn your phone on:
Press
Once your phone is on, it may display "Looking for service...," which
indicates that your phone is searching for a signal.When your phone finds a
signal, it automatically enters standby mode – the phone's idle state.At this
point, you are ready to begin making and receiving calls.
If your phone is unable to find a signal after 15 minutes of searching, a
Power Save feature is automatically activated.When a signal is found, your
phone automatically returns to standby mode.
In Power Save mode, your phone searches for a signal periodically without
your intervention.You can also initiate a search for service by pressing any
key (when your phone is turned on).
The Power Save feature helps to conserve your battery power when you
Tip:
are in an area where there is no signal.
Turning Your Phone Off
To turn your phone off:
Press and hold
animation on the display screen.
Your screen remains blank while your phone is off (unless the battery is
charging).
18 Section 2A: Phone Basics
.
for two seconds until you see the powering down