Setting The Self-Timer - Sanyo M1 Owner's Manual

Setting the Flash
To activate the flash:
1.
From camera mode, select Options (right softkey) > Flash.
2.
Select one of the following options and press

Setting the Self-Timer

To activate the self-timer:
1.
From camera mode, select Options (right softkey) >
Self-Timer.
2.
Highlight the length of delay you want the timer to use (10 Seconds
or 5 Seconds) and press
3.
Select Start (left softkey) when you are ready to start the timer. (
appears on the upper right portion of the Main LCD during the self-
timer countdown.)
4.
Get ready for the picture. (When the timer is down to three seconds,
the self-timer icon will turn red and the phone will begin to beep.)
To cancel the self-timer after it has started:
Select Cancel (right softkey).
While the self-timer is active, all keys are disabled except Back , END ,
Note:
and the right softkey button ( Cancel ).
142 Section 2I: Using the Built-in Camera
Off to deactivate the flash.
On This Shot to activate the flash for one shot.
On Always to activate the flash for all pictures.
Auto to activate the flash automatically.
.
: