Table of Contents
Advertisement
Softkeys
You can select the menus, which are described at the bottom line of the display by pressing the
corresponding softkeys (left/right). In this User Manual, the explanation for selecting such
menus are as shown below:
•
Press Contacts(right softkey).
Turning Your Phone On and Off
Turning Your Phone On:
To turn your phone on, press END/ .
Once your phone is On, it displays "Looking for service...", indicating that your phone is
searching for a signal. When your phone finds a signal, it automatically enters standby mode
–the phone's idle state. At this point, you are ready to begin making and receiving calls. If your
phone is unable to find a signal after 15 minutes of searching, a Power Save feature is
automatically activated. When a signal is found, your phone automatically returns to standby
mode.
In power save mode, your phone searches for a signal periodically without your intervention.
You can also initiate a search for PCS Service by pressing any key (when your phone is turned
on).
Tip: The Power Save feature helps to conserve your battery power when you are in an area
where there is no signal.
Turning Your Phone Off:
Press and hold END/ for two seconds until you see the powering down animation on the display
screen. Your screen remains blank while your phone is off (unless the battery is charging).
Unlocking the Phone
1. Press END/ to turn the phone on.
2. Press Unlock (left softkey).
3. Enter your four-digit lock code. For security purposes, the code is not visible as you type.
Using the Battery
Installing the Battery
To install the Li-Ion battery:
-To install, insert the battery into the opening on the back of the phone and gently press down
until the latch snaps into place.
Removing the Battery
To remove your battery:
1. Make sure the power is off so that you don' t lose any stored numbers or messages.
2. Press the battery release latch down and remove the battery from the phone at a
45-degree angle.
8
Advertisement
Table of Contents
