Receiving A Ready Link Call - Sanyo M1 Owner's Manual

Receiving a Ready Link Call

To receive a Ready Link call:
1.
Make sure your phone's Ready Link mode is enabled. (See "Setting
Ready Link Mode" on page 163.)
2.
When you receive a Ready Link call from a contact,"R-Link Call," the
contact's name, and the Ready Link number are displayed. (You do
not need to take any action to answer the call.)
3.
If the person placing the call has kept the floor (held the Ready
Link/Recorder button), you will see the contact's name and Ready
Link number along with "has floor," and you will hear the caller
speaking.
4.
When the caller finishes speaking and releases
"Floor is open" on the display screen. Press and hold
the floor and reply to the caller. (You will see "You have floor" and hear
a tone confirming that you may speak.)
5.
When the conversation is finished, press
You can also receive a Ready Link call with the phone closed. Press and
Tip:
hold the Ready Link button to take the floor when the floor is open.
You can change the volume and the speaker setting while a Ready Link
Note:
call is activated. Volume: Adjust the voice volume by using the Side
Volume key or by pressing the navigation key up or down (except when
you are pressing and holding the Ready Link button). Speaker: Switch
the speaker on or off by pressing the Speaker button.
170 Section 2J: Using Ready Link
When you receive a group call,"Group Call," the group
member's name, and the Ready Link number are displayed.
, you will see
to take
.