Tennant 7100 Use And Care Manual
Tennant 7100 Use And Care Manual

Tennant 7100 Use And Care Manual

Rider floor scrubber
Hide thumbs Also See for 7100:

Advertisement

Available languages

Available languages

FOR SAFETY: READ OPERATOR'S MANUAL BEFORE OPERATING MACHINE.
WARNING: Failure to follow these warnings may result in personal injury, electrocution, electrical shock, fire or explosion: Do not use flammable
liquids or operate machine in or near flammable liquids, vapors or combustible dusts. Do not pick up flammable materials or reactive metals. Keep
sparks and open flame away. Keep battery hood open when charging. Disconnect battery cables before servicing machine.

DAILY: BEFORE EACH USE

1. Check the battery
charge levels and charge if
needed. (See below).
Make sure solution tank
6.
is empty and screen filter is
clean.

DAILY: AFTER EACH USE

Drain and clean the
1.
recovery tank and if ES
equipped, clean screen
filter.
6. Check the vacuum hose
for blockage.
MONTHLY:
1. Lubricate all grease
fittings and steering chain
with Lubriplate EMB grease
(Tennant p/n 01433- - 1).
ATTENTION: FOR MACHINE REPAIRS, CONTACT AN AUTHORIZED SERVICE CENTER.
613779 Rev 00 (10- -02)
7100 Rider Floor Scrubber
USE and CARE Guide
2. Install brushes or pads
on machine. Check for
entangled debris.
Inspect the tank cover
7.
seals and clean if needed.
Drain and clean the
2.
solution tank and clean
screen filter.
7. Check the scrub head
pads/brushes for wear and
entangled debris.
Refer to the Operator's Manual for further details.
2. Check drive belt tension.
(Cylindrical Scrub Head
Only)
3. Empty the debris tray.
(Cylindrical Scrub Head
Only)
Fill solution tank with
8.
water to approx. 5" from top
and add approved products.
Clean the vacuum fan
3.
inlet filter.
8. Empty the debris tray.
(Cylindrical Scrub Head
Only)
3. Clean the battery
terminals and cables. Use a
strong solution of baking
soda and water
Clean squeegee and
4.
turn the blade over if worn.
9. If ES equipped, fill recovery
tank to lower sensor with water
and add approved products.
Check the battery
4.
charge levels and charge if
needed. (See below).
BATTERY CHARGING
INFORMATION:
Before charging, check
battery fluid level. The fluid
level (A) should cover the
battery plates (B) a 1/4". Add
distilled water if needed. DO
NOT OVERFILL.
Check brake adjustment.
4.
Make sure recovery tank
5.
is empty. If ES equipped,
clean screen filter.
FOR RECOMMENDED
APPROVED CLEANING
PRODUCTS, CONTACT YOUR
AUTHORIZED DISTRIBUTOR
OR SERVICE CENTER.
Clean squeegee and
5.
turn the blade over if worn.
B
A
When disconnecting the
battery charger always
remember to unplug the
charger from the wall outlet
first.
Check tires for damage
5.
and wear.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 7100 and is the answer not in the manual?

Questions and answers

Summary of Contents for Tennant 7100

  • Page 1 7100 Rider Floor Scrubber USE and CARE Guide FOR SAFETY: READ OPERATOR’S MANUAL BEFORE OPERATING MACHINE. WARNING: Failure to follow these warnings may result in personal injury, electrocution, electrical shock, fire or explosion: Do not use flammable liquids or operate machine in or near flammable liquids, vapors or combustible dusts. Do not pick up flammable materials or reactive metals. Keep sparks and open flame away.
  • Page 2 Pulidora de pisos 7100 Guía de USO y MANTENIMIENTO PARA SU SEGURIDAD: LEA EL MANUAL DE INSTRUCCIONES ANTES DE PONER LA MAQUINA EN FUNCIONAMIENTO. ADVERTENCIA: Ignorar esta advertencia podrá traer como consecuencia daño personal, electrocución, choque eléctrico, incendio o explosión. No utilice líquidos inflamables ni ponga la máquina en funcionamiento cerca de líquidos inflamables, vapores o residuos combustibles.

Table of Contents