Power Connector - HP 14 Maintenance And Service Manual

Power connector

Description
Power connector
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the rubber feet (see
5. Remove the bottom cover (see
6. Remove the battery (see
7. Remove the right hinge screw and lift the right hinge (see
To remove the power connector:
1. Disconnect the power connector cable (1) from the system board.
2. Lift the power connector (2) to remove it.
Reverse this procedure to install the power connector.
Computer feet on page
Bottom cover on page
Battery on page 35).
31).
33).
Display assembly on page
Component replacement procedures
Spare part number
L23188-001
57).
43