Solid-State Drive - HP 14 Maintenance And Service Manual

Solid-state drive

Description
Solid-state drive, PCIe:
● 512 GB
● 256 GB
Solid-state drive, SATA-3, TLC:
● 256 GB
● 128 GB
Optane memory module, 16 GB
Solid-state drive bracket
Solid-state drive board
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Remove the rubber feet (see
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to install the solid-state drive.
Computer feet on page
Bottom cover on page
Battery on page
Solid-state drives are designed with notches to prevent incorrect insertion.
31).
33).
35).
Component replacement procedures
Spare part number
L25984-001
L25983-001
L25982-001
L25981-001
L34406-001
L24488-001
L24487-001
41