HP 14 Maintenance And Service Manual page 62

a. In the order indicated on the heat sink, remove the four Phillips M2.0×4.0 screws (1) that secure
the heat sink to the system board.
b. Remove the heat sink (2) from the system board.
NOTE: The thermal material must be thoroughly cleaned from the surfaces of the heat sink and the system
board components each time the heat sink is removed. Replacement thermal material is included with the
heat sink, processor, and system board spare part kits.
The following illustrations show the replacement thermal material locations.
● Discrete graphics: Thermal paste is used on the heat sink (2) (4) and associated system board
components (1) (3).
54 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts