Injector - Removal And Installation - MTU 16V2000M72 Operating Instructions Manual

8.7.2 Injector – Removal and installation
Preconditions
☑ Engine is stopped and starting disabled.
Special tools, Material, Spare parts
Designation / Use
Socket wrench
Puller
Double-head box wrench
Open-end wrench bit
Box wrench
Alignment device
Assembly compound (Kluthe Hakuform 30-15)
Engine oil
Pressure pipe tube
Hold-down clamp screw
Injector
WARNING
Fuels are combustible and explosive.
Risk of fire and explosion!
• Avoid open flames, electrical sparks and ignition sources.
• Do not smoke.
• Wear protective clothing, protective gloves, and safety glasses / facial protection.
Preparatory steps
1. Close off fuel supply to engine.
2. Remove cylinder head cover (→ Page 111).
Remove injector
1. Remove HP line (5) using socket wrench.
2. Disconnect cable (4) at injector.
3. Remove screw (2).
4. Take off hold-down clamp (3).
5. Remove injector (1) with puller.
6. Remove O-rings from injector.
7. Mask all connections and bores or seal with
suitable plugs.
M015650/06E 2018-05 | Injection Valve / Injector | 113
Part No.
F30451502
F6790629
F30011450
F30025897
F30451199
F6790507
X00067260
(→ Spare Parts Catalog)
(→ Spare Parts Catalog)
(→ Spare Parts Catalog)
Qty.
1
1
1
1
1
1
1