How Many Pool Accessories? - Hayward OmniHub Installation Manual

Which Relay is it Wired to? Touch the box to select the Smart Relay that is wired to the
lights.
How Many Pool Accessories? Select the number of accessories that will be used for this Body of
Water only. You'll have an opportunity to configure accessories for the spa and also the backyard
at a later point.
If "1"or more is selected:
Select and Configure Accessories At this screen you can add, delete and configure
your accessories. Select the desired accessory, then touch the Advance button. When
finished configuring accessories, you'll be returned to this same screen. Touch the Done
button and advance to the next section of configuration. Refer to the following information
when configuring accessories:
Type of Accessory? Touch the box and select the type of accessory used. Choices are
Laminars, Jets, Blower and Other.
Name of Accessory - Touch the box and use the keyboard to name the accessory.
Does Accessory Have a Pump? Select whether the accessory has a dedicated pump. If
so, the OmniHub will turn this pump on when the accessory is scheduled to run.
If Yes is selected:
What Type? Select the type of pump used. The choices are Single Speed, Two
Speed and VSP.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
If single speed or two speed pump is selected:
Which Relay is it Wired to? If using a single speed or two speed
pump, you'll be asked which relay(s) is wired to the pump. If a value
is already shown in the box(es), advance to the next screen. If no
value is shown, selecting the box will bring you to a table showing all
detected relays. Select the proper relay(s) from the table and touch
the Done button. The relay(s) should now be shown in the box(es) and
you can advance to the next screen to continue the pump configura-
tion.
If VSP is selected:
Which Hayward Unique Address? If using a VSP for your accessory
pump, you'll be asked what is the Hayward Unique Address (HUA). If
a value is already shown in the box, advance to the next screen. If
no value is shown, selecting the box will bring you to a table show-
ing all detected devices. Select the proper HUA from the table and
touch the Done button. The address should now be shown in the
box and you can advance to the next screen to continue the VSP
configuration.
Pump Capacity - Set the minimum and maximum RPM of the pump.
Refer to your pump manual for more information.
40