Table of Contents
Advertisement
Standardized parts
Standardized parts are machine parts obtained from free trade outlets in accordance with
their necessary dimensions, materials and surface finish. A detailed list can be found in the
"Standardized parts" section.
Other parts
Other parts are small parts required to complete the exploded drawing. However, these parts
cannot be supplied as individual spare or repair parts. The delivery in assembly units (e.g.
complete terminal box) is possible on request.
The following supply commitments apply to replacement machines and repair parts following
delivery of the motor:
● For up to 3 years after the delivery of the original machine, in the event of total machine
failure, Siemens will supply a comparable replacement machine with regard to the
mounting dimensions and functions; it is possible that this will involve a new series.
● If a replacement machine is supplied within the 3 year period, this does not mean that the
warranty restarts.
● Replacement machines delivered after the active production of the machine series are
also identified as spare motors on the rating plate.
● Spare parts are offered only for these spare motors on request; repair and replacement
are not possible.
● After a period of 3 years (after the delivery of the original machine), it is only possible to
repair these machines (depending on the availability of the spare parts required).
● For up to 5 years after the delivery of the original motor, spare parts will be available and
for a further 5 years, Siemens will provide information about spare parts and will supply
documents when required.
10.8
Ordering example
End shield, drive end
Machine type *
Ident: No. *
* corresponding to the rating plate
Take the type and serial number from the rating plate and the machine documentation.
When replacing rolling-contact bearings, in addition to the bearing identification code, the
replacement code for the bearing version is required. Both of these codes are specified on
the rating plate and in the machine documentation. They are also shown on the installed
bearings.
The graphical representations in this chapter show schematic diagrams of the basic
versions. They are used for spare part definitions. The supplied version may differ in details
from these representations.
Standard motors SH 63 ... 355
Operating Instructions, 12/2018, A5E38483075A
10.8 Ordering example
1.40 End shield
1LE1002-1DB43-4AA0
E0605/0496382 02 001
Spare parts
119
Advertisement
Table of Contents
