Ordering Example - Siemens SIMOTICS SD 1LE5 Operating Instructions Manual

• Replacement machines delivered after the active production of the machine series are also
identified as spare motors on the rating plate.
• Spare parts are available only on request for these spare motors. Repair or replacement is
not possible.
• After a period of 3 years (after the delivery of the original machine), it is only possible to
repair these machines, depending on the availability of the spare parts required.
• After the delivery of the original motor, spare parts will be available for up to 5 years. For
an additional period of 5 years, Siemens provides information about spare parts, and
when required, provides documentation.
10.5

Ordering example

Table 10- 1
End shield, drive end
Machine type *
Ident: No. *
* corresponding to the rating plate
Take the type and serial number from the rating plate and the machine documentation.
When replacing rolling-contact bearings, in addition to the bearing identification code, the
replacement code for the bearing version is required. Both of these codes are specified on the
rating plate and in the machine documentation. They are also shown on the installed
bearings.
The graphical representations in this chapter show schematic diagrams of the basic versions.
They are used for spare part definitions. The supplied version may differ in details from these
representations.
1LE5, 1PC4 shaft height 315/355
Operating Instructions, 10/2020, A5E41454666A
Ordering example
10.5 Ordering example
1.40 End shield
1LE5504-3AB73-4AB0
UC 1504/156750601
Spare parts
109