Table of Contents
Advertisement
Spare parts
10.3 Example for ordering smoke extraction motors
Other parts
Other parts are small parts required to complete the exploded drawing. They cannot,
however, be supplied as individual spare or repair parts. The delivery in assembly units (e.g.
complete terminal box) is possible on request.
The following supply commitment apply to replacement machines and spare parts following
delivery of the motor:
● For up to five years, in the event of total machine failure, Siemens will supply a
comparable machine with regard to the mounting dimensions and functions.
● Spare parts will be available for up to five years.
● After the time period of up to five years, Siemens provides information about spare parts
and will supply documents when required.
● Spare machine deliveries after the active production of the machine series are also
identified as "Spare motor" on the nameplate. Spare parts are offered only on request for
these machines.
10.3
Example for ordering smoke extraction motors
Ordering example
End shield, drive end
Machine type *
ID no. *
* corresponding to the rating plate
Take the type and serial number from the rating plate and the machine documentation.
When replacing rolling-contact bearings, in addition to the bearing identification code, the
replacement code for the bearing version is required. Both of these codes are specified on
the rating plate and in the machine documentation. They are also shown on the installed
bearings.
The graphical representations in this chapter show schematic diagrams of the basic
versions. They are used for spare part definitions. The supplied version may differ in details
from these representations.
84
1.40 End shield
1PC1300-1DB43-4AA0
UD1303/9-4116-1
Operating Instructions, 03/2016, 5 610 80000 40 018
Smoke extraction motors
Advertisement
Table of Contents
