Directed Electronics DB3 Installation Manual page 13

* If the LED starts to flash orange, it indicates the vehicle is equipped with a factory
remote starter. Refer to "LED Diagnostics & Troubleshooting" for more information.
Press the programming button 5 times to skip the CAN programming. The LED will
3
turn OFF quickly, and it will then turn ON solid orange 3 seconds.
4
The module is now programmed. Remove the key from the ignition barrel.
You have successfully completed the module programming sequence.
Push-to-Start (PTS) vehicles without CAN
Wait until the LED turns ON solid red.
1
Note: To skip the bypass programming, press the programming button 5 times. The
LED turns ON solid orange.
Open the OEM key fob and remove the battery, then place the OEM key fob in front
2
of the Push-to-Start (PTS) button.
Press the Push-to-Start (PTS) button twice to turn the ignition ON. The LED flashes red
3
slowly for afew seconds to indicate the key is in learning mode. It then turns ON solid
green.
Press the programming button 5 times to skip the CAN programming. The LED will
4
turn OFF quickly, and it will then turn ON solid orange 3 seconds.
The module is now programmed. Press the PTS button once more to turn the ignition
5
OFF.
You have successfully completed the module programming sequence.
13
403.TL1 5.02 2010 Toyota Camry (Smart Key)
© 2017-02-17 Directed. All rights reserved.