Compliance - ADS-tec IRF2000 series Instruction Manual

IRF2000 series – DNV GL variant

2.8 Compliance

The manufacturer hereby declares that this device has been marked with the CE mark in accordance
with the basic requirements and other relevant conditions of the following European Directives:
•
2011/65/EU, RoHS Directive
•
2014/30/EU, EMC Directive
•
2014/53/EU, RED Directive
•
2014/35/EU, Low Voltage Directive
A corresponding EU conformity declaration is available for competent authorities at the manufacturer
and can be viewed upon request.
Recommendation for use:
For full compliance with the EMC legislation, all components and cables used for
device connection must also be compliant with these requirements. It is therefore
necessary to employ BUS and LAN cables with shielded connectors and these
must be installed as per the instructions contained in the instruction manual.
The devices with a DNV GL logo on their type plate
also comply with the following requirements:
•
DNV GL rules for classification – Ships
•
IEC 60945 Ed. 4 (2002-08) Maritime navigation and radiocommunication equipment and systems –
General requirements – Methods of testing and required test results
•
E10
Application:
Temperature: B; Humidity: B; Vibration: A; EMC: B; Enclosure: Required protection according to DNV
GL Rules shall be provided upon installation on board.
ATTENTION
Disturbance of the function of compasses by radio-frequency fields!
•
Observe the minimum permissible distance between the device and compasses
of 17 cm.
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
9