Wall Mounting - ADS-tec IRF2000 series Instruction Manual

IRF2000 series – DNV GL variant

5.2.2 Wall mounting

The device can be mounted according to the VESA 75 standard on a suitable mounting surface.
To do so, use screws size M4. Make sure that they do not enter more than 5 mm into the housing.
ATTENTION
Risk of short circuits
If the screws are too long, they could touch the printed circuit board inside the housing
and cause a short circuit.
 Only use screws with an adequate length.
Fig. 3
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
21