Related Manuals for ADS-tec IRF3000 Series
Summary of Contents for ADS-tec IRF3000 Series
- Page 1 Translation of the original instruction manual Version 1.1 Updated 2023-01-11 Instruction manual Industrial router & firewall IRF3000 series...
-
Page 2: Table Of Contents
Scope of delivery Environmental conditions Installation ..........................18 External device dimensions IRF34x1 External device dimensions IRF38x1 Top-hat rail mounting Optional accessory: Attaching the VESA holder Optional: Attaching antennas © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... - Page 3 Operating-mode related LED status displays 7.5.1 Boot-up 7.5.2 Resetting to default settings 7.5.3 Firmware update Technical data ........................29 Service & support ........................30 ADS-TEC support Company address © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany...
-
Page 4: Notes
The original version of this instruction manual was written in German. All non-German versions of this instruction manual are translations of the German instruction manual. 1.2 Manufacturer The manufacturer of the product is ads-tec Industrial IT GmbH. The company is referred to in the following as ADS-TEC. 1.3 Limitation of liability... -
Page 5: Relevant Device Documentation
• Technical data sheet (see download area) • Website: You can download drivers, software, user manuals, leaflets and flyers from the Download area of our website www.ads-tec.com © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 6: Safety Instructions
Indicates a possible danger. If not avoided, light or minor injuries could result. ATTENTION Indicates a possibly damaging situation. If not avoided, the system or something in its surroundings could be damaged. © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 7: Symbols
All data, text and figures were prepared to the best of our knowledge. They do not represent any assurance for the properties themselves. Despite taking utmost care, no liability can be assumed for accuracy, completeness and actuality of the information. Subject to changes. © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 8: Trademarks
® All other third-party trademarks used are hereby acknowledged. In the case of infringement of trademark rights, ADS-TEC reserves the right to exercise all rights. 2.7 Copyright This instruction manual is protected by copyright. For the authorised user, simple usage rights are granted within the scope of the intent of the contract. -
Page 9: Conformity
In such a case, the user must correct the interference at his own expense. Compliance applies for models with a corresponding FCC marking on the type plate. © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 10: Operating And Safety Instructions
The instruction manual contains the most important information for safely operating the device. Appropriate storage, proper transport, installation and commissioning, as well as careful operation are prerequisites for ensuring safe and proper operation of the device. © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 11: Safety Instructions
Should the control system have evident signs of damages caused, e.g., by improper operation or storage conditions or due to improper use or handling, the device must be shut down immediately. Ensure that it is secured against being started up accidentally. © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 12: Warranty / Repairs
In the case of improper use, ADS-TEC shall not accept responsibility or liability for injury or damage that is directly or indirectly attributable to the handling of the device. Should the device have evident signs of damages caused, e.g., by improper operation or storage conditions or due to improper use or handling,... -
Page 13: Safety Instructions On Mobile Radio
Per the requirements of the U.S. Federal Communications Commission • (FCC) and ISED (Industry Canada), maintain a minimum distance of 20 cm between the transmitting antennas and people. © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 14: Calculation Example For The Transmission Power (Eirp)
= Transmission power of the wireless card (see data sheet of the device) = Losses caused by attenuation in coaxial cables and connectors loss = Antenna gain gain © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 15: Notes On Using The Device According To Ul Approval
The device contains an internal fuse at the voltage input. This fuse and all other internal components must not be replaced by service personnel, but only by the manufacturer. © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 16: Introduction
Only with IRF38: 1 x 8-pin plug for digital I/Os #3…5 1 x Quick-start guide Optional: 2 x Mobile communications antenna Optional accessory: 1 x VESA mounting plate © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 17: Environmental Conditions
The device can be put into operation and used under the following conditions. Failure to observe any one of these conditions will invalidate the warranty of the device. ADS-TEC cannot be held liable for any damages arising from improper use and handling. See also chapter 8 Technical data. -
Page 18: Installation
IRF3000 series Instruction manual v1.1 5 Installation 5.1 External device dimensions IRF34x1 © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 19: External Device Dimensions Irf38X1
IRF3000 series Instruction manual v1.1 5.2 External device dimensions IRF38x1 © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 20: Top-Hat Rail Mounting
Screw the mounting plate directly onto the device label using the screws provided. The positions of the screw holes are marked with target crosses ( ) on the label. © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 21: Optional: Attaching Antennas
Screw the mobile communications antennas to the antenna connections (WWAN AUX/MAIN) directly or via an SMA extension cable. IRF38 only: Screw the SMA cable of the GPS antenna to the GNSS connection. • © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 22: Electrical Interfaces
/ AWG20 and appropriate cable end sleeves. To minimise mechanical strain between the individual wires and the plug, the distance between jacket and plug should be at least 30 mm. © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 23: Modbus Rtu (Rs-485)
6.4 Digital I/O #3…5 These electrically isolated inputs and outputs are only available with IRF38. Signal Power supply +24 VDC ± 20 % Digital inputs #3…5 Digital outputs #3…5 Reference potential © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 24: Smart Card Reader And Slot For Sim Card
Complex IT infrastructures with a large number of devices can be managed, monitored and controlled easily and conveniently using Big-LinX ® . Further information on Big-LinX can be found at: http://www.ads-tec.de/industrial-it/cloud-big-linx/big-linx.html © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 25: Commissioning
(The last set of digits must be a number between 1 and 253. In this − example: "100".) Subnet mask: 255.255.255.0 (Some input masks require the input of the short notation /24 − instead.) Confirm your entries by clicking on OK. © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 26: Calling Up The Device Web Interface
Often, local subnet addresses (e.g. 192.168.x.x) are also diverted to a proxy server. In this case, it is possible to select the "Bypass proxy server for local addresses" option to enter the address in question. © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 27: Front Leds
Firmware update of the radio module (5 Hz) Logged in, offline Logged in, standby (dial-on-demand) Logged in, online Legend: LED status Representation Illuminates green Flashes green Illuminates red Illuminates orange Flashes orange © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 28: Operating-Mode Related Led Status Displays
The PWR-LED flashes slowly during this process. During a firmware update of the mobile radio module, the yellow WWAN-LED flashes with a • frequency of 5 Hz. © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 29: Technical Data
-30 ... +70 °C for storage -40 ... +85 °C You can find further information about the device in the data sheet on our website: www.ads-tec.com © ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany... -
Page 30: Service & Support
ADS-TEC does not provide support services for any device that was not purchased directly from ADS-TEC. In this case, maintenance and support is provided by the partner company.