3. Place the gasket (2b) on the valve seat (2a). Grease
the threads of the valve seat (2a) then install into the
fluid housing (22). Torque to 20-25 ft-lb (27-34
N•m). See F
. 13.
IG
2a
2b
22
F
. 13
IG
4. Install the spring guide (16) and seat it against the
needle. Loosely thread both setscrews (17) into the
spring guide then alternately and evenly tighten the
setscrews to 10-15 in-lb (1.1-1.6 N•m). Fill the set-
screw cavities with petroleum jelly. See F
F
. 14
IG
3A2799C
ti19278a
. 14.
IG
16
17
ti19279a
5. If the spring (19) was removed, grease the spring
adjuster (20) and place the spring on the adjuster
then drop into the gun body (1). See F
F
. 15
IG
6. Push the fluid housing (22) onto the gun body (1)
until fully seated. Apply medium strength (blue)
®
Loctite
or equivalent to setscrew (15). Tighten the
setscrew to 60-75 in-lb (6.8-8.5 N•m). Fill the set-
screw cavity with petroleum jelly. See F
1
22
F
. 16
IG
. 15.
IG
19
20
1
ti19280a
. 16.
IG
15
ti19272a
Service
11