Test The Gun After Service - Graco XHF Instructions And Parts

Includes an xhd rac guard and xhd429 switchtip

Table of Contents

Enlarged version

Service

7. Position the trigger (24) on the gun body. Insert the

pivot pin (23) into the top hole (A) and secure with

the screw (13) on the other side. Ensure there is an

e-clip (26) on one end of the trigger pin (18). Slide

the pin through lower trigger holes and through the

slot (B) in the spring guide (16) -- turn the spring

guide to align, as needed. Install the other

e-clip (26) onto pin. See F

. 17

8. If it was removed, install the spring tension screw

(21) at the rear of the gun. Then turn the screw in

until it stops. See F

. 18

. 17.

B,16

ti19271a

. 18.

ti19281a

Test the Gun After Service

1. Lock the gun trigger lock. Connect a hose to the

gun. Start and prime the pump.

2. Release the gun trigger lock. Trigger the gun into a

waste container until fluid dispenses. Release the

trigger to be sure the gun immediately stops spray-

ing and that there are no leaks in any gun connec-

tions.

3. Lock the gun trigger lock.

4. Install the tip guard (9) before regular use. See F

19.

. 19

ti19264a

3A2799C

Table of Contents