Schwinn AC Performance Assembly Manual page 6

Hide thumbs Also See for AC Performance:

First, tighten the fore/aft adjustment pop pin into

the handle bar post using a 21mm open-end-

ed wrench then loosen the pop pin by turning

counter-clockwise. Pull outwards on the pin

while sliding the handlebars into the post then

thread the M5 x 16mm screw into the underside

of the handlebars, tightening with a 4mm allen

key to secure.

Loosen the handlebar post height adjustment

pop pin on the bike's frame by turning the knob

counter-clockwise, then pull outwards on the pin

while sliding the handlebar post assembly into

the frame.

IF 4IIII POWER SENSOR IS BEING INSTALLED,

SKIP THIS STEP AND REFER TO INSTALL DOCU-

MENTATION FOR THE 4IIII CRANK ARM. Install

the left crank arm onto the left side of the bot-

tom bracket ensuring that the right crank arm is

at the 12 o'clock position while the left crank arm

is at the 6 o'clock position. Finally, use a torque

wrench and a 8mm allen key socket to secure

one (1) piece of the crank bolt through the crank

arm and into the bottom bracket, torquing to 33-

37 ft-lbs (48 Nm)

Install the pedal into the crank arm then use a

torque wrench and a 8mm allen socket to secure

one (1) piece of the crank bolt from the other

side of the pedal, torquing to 33-37 ft-lbs (48

Nm).Repeat this step for the rider left side pedal.

CAUTION: The pedal MUST be torqued to the above

specifi cations otherwise a failure of the pedal may

occur.

Page 5

Ac sport