AC Sport
Required Tools:
•
5mm Allen Key
•
13mm Open-ended Wrench
•
12mm Open-ended Wrench
•
8mm Allen Socket
•
Torque Wrench
1.
Install the front stabilizer using a 5mm allen key
and a 13mm open-ended wrench to secure two
(2) pieces each of the M8 x 45mm screws and
M8 nuts. Be sure to place one (1) piece of the M8
washer between the nuts and the stabilizer as
well as the screws and the frame. Repeat this step
to attach the rear stabilizer to the frame.
2.
Tighten the fore/aft adjustment pop pin into
the seat post slider using a 21mm open-ended
wrench then depress the button on the seat post
while sliding the seat slider onto the seat post.
3.
Loosen the seat post height adjustment pop pin
on the bike's frame by turning the knob count-
er-clockwise, then pull outwards on the pin while
sliding the seat post assembly into the frame.
Page 4