Gen5 Software
Gen5 software supports all Synergy H1 reader models. Use Gen5 to control the reader and
the dispense module (if equipped), perform data reduction and analysis on the
measurement values, print or export results, and more. This section provides brief
instructions for working with Gen5 to create protocols and experiments and read plates.
Refer to the Gen5 Help system for more information.
Define the Filter Cube
The reader's onboard software is configured with the filter and mirror values and their
locations in the filter cube. When Gen5 communicates with the reader, it "asks" for this
information and then stores it in a Filter Cube table. If you make any changes to the
filter cube, you must define the changes in Gen5 and send the information to the
reader.
•
Select
click
•
Click
system for additional instructions.
Synergy H1
Tip priming
trough
Figure 9
System > Instrument Configuration
View/Modify
.
Setup
and then click the
Priming plate
. Select
Filter Cube
tab. Refer to the Gen5 Help
21
Gen5 Software |
Synergy H1
, and