External Components; Internal Components; Filter Cube - Biotek Synergy H1 Instructions For Use Manual

External Components

The entry for the
dispense outlet tubes
and injectors (if
equipped)
The access door for
the filter cube and

internal components

The tubing for the gas
controller module in
bottom tray of
instrument (if
equipped)
power switch
The
microplate carrier eject
button
Internal Components
This section introduces some internal components that may require replacement or
cleaning over time. Not all of these components exist in all Synergy H1 models.

Filter Cube

The Synergy H1 is equipped with a filter cube that contains excitation and emission
filters, mirrors, and, if required, polarizing filters. Each filter cube contains two filter
sets, each of which contains one excitation filter, one mirror, and one emission filter.
The filter cube is accessed through a hinged door in the front of the instrument.
Synergy H1
and
Do not open the door to access the filter cube during instrument
operation. Doing so may result in invalid data.
The Gen5 Filter Cube Table must match the actual filter cube contents.
External Components |
Figure 7
17
back panel
The
contains the
communication and
dispenser ports, and
the input for the power
supply
The light-blocking
microplate carrier
access door