x 28
x 2
2mm
3
Position the appliance on the rails, making sure the pins are correctly inserted
in the housings, then fix it with the screws supplied. If the height of the appliance
requires adjusting, use the spacer disks provided.
7
INSTALLATION INSTRUCTIONS
x 1
1
Position the rails on the sides of the
cabinet. Fix with the screws provided,
then extend the rails completely.
Position and fix the lock hook with
●
the four screws provided, as shown.
If the coffee maker is installed over a
●
warmer drawer, use the top surface
of this as a reference to position the
rails. In this case, there will be no
surface to rest the rails on.
2
Fix the power cable with the clip. The power cable must be long enough to allow
the appliance to be pulled out from the cabinet to fill the coffee bean container.
The appliance must be earthed in compliance with legislation.
●
Electrical connections must be performed by a qualified electrician following
●
the instructions.
4
If necessary, correct alignment of the appliance by positioning the spacers
supplied under or at the sides of the support.
5
To lift the appliance in the front (max. 2mm) turn the latch as shown.
approx. 350mm
5
| 7
COFFEE MAKER INSTALLATION GUIDE