Connector Installation On The Cable - Nexans Euromold K200LR Installation Instructions Manual

Page 6/9

CONNECTOR INSTALLATION ON THE CABLE

1 Thoroughly clean cable reducer and contact.
2 Lubricate* the cable reducer and inside surface of the connector.
3 Slide the connector housing on to the reducer until it cannot advance any further.
4 Insert the supplied hex key into the pin contact. Insert the threaded end of the pin contact into the mating part and
engage threads. Take care not to cross threads.
5 Tighten with the supplied hex key until the key has taken a set.
NOTE:
-The hex key must be inserted in the pin contact until it cannot advance any further.
-The hex key is only usable twice (once every side).
clean thoroughly
cable reducer
lubricate
* USE ONLY THE SILICONE LUBRICANT SUPPLIED
pin contact
hex key