5-6 Clear the existing saving data from the memory
( Lower display show " CLr " )
a. Use "
button " ( 3-3, Fig. 1 ) to select " YES " or " no ".
▲
* YES : It will execute the memory clear function..
* no : It will be not to clear the memory.
b. If select " YES ", press the " Enter button " ( 3-4, Fig. 1 )
the beeper will sound three sounds for warning,
if really intend to clear the memory, then press the
" Enter button " again.
5-7 Code entering for the further calibration usage
( Lower display show " CodE" )
The upper display will show 0.
The code setting is used for the further technician
service usage, it do not enter any new code, just press
the " Enter button " ( 3-4, Fig. 1 ) will finish the
Advanced Setting Procedure.
6. SEND THE DATA OUT
1) To send the data out from the meter, exit the
" Hold function " and the " Record function " at first.
2) Press the " Send button " ( 3-2, Fig. 1 ) at least 5
seconds until the lower display show " r232 ", then
release the button.
108
r232
13
The total data logger
no. that saved into
the memory.