Display Unit; Ac Power Strip - Furuno WR-2100 Installation Manual

5.4. Display Unit

Sample image of DPU
Type A: Neousys Nuvo-5006LP
③
⑤
Caution: When using DPU at overrsea, some DPU has to switch the voltage
(e.g.: AC115V or 230V).

5.5. AC Power strip

Setup 4 or more outlet of AC power strip (3 core) for DPU, external data storage device, and
SPU/ATU. UPS and Switching Hub / Router will be necessary (that depends on an order) for
option.
Notice: Lay the LAN cable between DPU and modem/router during installation when customer
prepares an internet environment with modem/router for using remote control.
ATU
①
④ ②
SPU
1. Setup Data Processing Unit
(1) Connect AC power supply cord from
electrical outlet to DPU.
Note: Power "ON" ATU first and then
power "ON" DPU.
② Connect LAN cable from DPU to ATU
(SPU), and setup IP address of DPU.
(192.168.31.110)
③ Connect LAN cable from DPU to ATU
(MONI-CON) and setup IP address on
DPU to 192.168.1.80. Use USB/LAN
(100MHz or higher) adapter for LAN
connection on DPU.
④ Connect LAN cable from router to DPU
for using Internet. (e.g.: 192.168.0.5)
⑤ Use appropriate display connection
(DP, DVI,
monitor.
Notice: Do not use the same IP address
as ATU.
DPU
External data
storage device
26
SSE-14-0023_17
D-sub15pin)for external