Peripherals Equipment - Furuno WR-2100 Installation Manual

3.6. Peripherals equipment

The purposes of using these peripherals are for remote control:
1. Wired router
Function
WAN port
LAN port
Input voltage
Remarks
2. SW HUB
Function
LAN port
Input voltage
Remarks
3. Uninterruptive Power Supply
Function
Output voltage
Input voltage
Remarks
4. External data storage device
Function
Capacity
Interface
Input voltage
Remarks
5. Remote Power Controller
Function
Capacity
Interface
Input voltage
Remarks
Connect with an external network
10/100/1000BASE-T, 1 port, MDI/MDI-X auto switch
10/100/1000BASE-T, 4 port or more, MDI/MDI-X auto switch
AC100V-240V, Single phase, 50/60 Hz
YAMAHA RTX810 or equivalent
Connect with LAN
10/100/1000BASE-T, 5 port or more, MDI/MDI-X auto switch
AC100-240V, Single phase, 50/60 Hz
ELECOM EHC-G05MN-HJ or equivalent
Automatically shut down after 10 minutes operation during a power
failure
More than 1,000VA
AC100-240V, Single phase, 50/60 Hz
APC Smart-UPS series w/ network or equivalent
Save scan data
3TB or more
USB3.0/2.0 x 1 port
AC100-240V, Single phase, 50/60 Hz
WD 3TB or equivalent
Reboot the power of equipments by remote
2-4 individual outlet power control (ON/OFF/Reboot/Schedule)
10BASE-T/100BASE-TX RJ-45X1, RS232
AC100-240V, Single phase, 50/60 Hz
AVIOSYS IP POWER series or equivalent
14
SSE-14-0023_17