SMC Networks ZSE20B Operation Manual page 15

Term
S Set pressure range
Slave Pressure switch
Switch output
U
Units selection function
W
Window comparator mode
Withstand voltage
Z Zero-clear function
The pressure range that can be set for switch output.
A Pressure switch whose settings are copied to when using the copy function.
Sometimes referred to as "ON-OFF output".
A function to change the units in which the measured pressure value is
displayed. The display units can only be changed if the product is equipped
this function. It is not possible to purchase the product with this function if the
product is used in Japan.
The product for Japan is displayed in SI only.
An operating mode in which the switch output is turned on and off depending
on whether the flow is inside or outside the range of two set values.
(Refer to the "List of output modes" on page 33.)
A measure of the product's resistance to a voltage applied between the
electrical circuit and case. Durability in withstanding voltage. The product may
be damaged if a voltage over this value is applied.
(The withstand voltage is not the supply voltage used to power the product.)
This function to adjust the displayed pressure to zero.
-14-
Definition
No.PS※※-OMU0006-A