SMC Networks ZSE20B Operation Manual page 13

Term
E
Error displayed
Error output
F
F.S.
(full span/full scale)
Fine adjustment mode
Fluid contact part (or wetted
part)
Function selection mode
H
Hysteresis
Hysteresis mode
I
Insulation resistance
K
Key-lock function
L Load impedance
M
Manual setting
Master Pressure switch
Maximum applied voltage
Maximum load current
Max. (Min.) load impedance
Measurement mode
Min. setting unit
N
Normal output
The code number displayed, identifying the error detected by the
self-diagnosis function of the pressure switch.
Refer to "Error indication function" on page
Switches the switch output to ON/OFF when an error is displayed.
Refer to "List of output modes" on page
Refer to "Error indication function" on page
Abbreviation of full span and full scale; difference between the minimum and
maximum rated pressure values. means the maximum fluctuation range of
the pressure switch rated value.
For example, when the rated pressure range is -0.100 to 1.000 [MPa]:
F.S. = 1.000 - (-0.100) = 1.100 [MPa]
(Reference: 1%F.S. = 1.100 x 0.01 = 0.011 [MPa])
Refer to "Display value fine adjustment (function)".
Part of the pressure switch which contacts detected fluid. Pressure sensor,
seal and fitting are included.
A mode in which setting of functions is performed. It is a separate menu from
the pressure setting. If any function settings need to be changed from the
factory default, each setting can be selected with "F".
The setting items are: operation mode, output type, display color, digital filter,
use of auto preset, analog/auto shift/copy, display value fine adjustment, sub
screen display, display resolution, use of power saving mode and use of
security code.
Difference between the points at which the pressure switch is turned ON and
OFF.
Refer to the "List of output modes" on page 33.
Insulation resistance of the product. The resistance between the electrical
circuit and the case.
Function that prevents changes to the settings of the Pressure switch
(disables button operation).
Refer to "Max. load impedance".
Manual pressure setup without using auto preset.
This term is used to distinguish between manual and auto preset pressure
setup.
A Pressure switch whose settings are copied when using the copy function.
The maximum voltage that can be connected to the output of an NPN device.
The maximum current that can flow to the output (output line) of the switch
output.
The maximum (minimum) load (resistance value and impedance) which can
be connected to the output (output wire) of the analog current output.
Operating condition in which pressure is being detected and displayed, and
the switch function is working.
Refer to "digit".
One of the switch output types. In hysteresis mode the switch output is turned
ON when pressure equal to or greater than the switch output set value is
detected. In window comparator mode, the switch output is turned ON when
pressure between the switch output set values (P1L to P1H) is detected.
(Refer to the "List of output modes" on page 33.)
-12-
Definition
74 for details of the errors.
33 for operating conditions.
74 for details of the errors.
No.PS※※-OMU0006-A