Printing on Fabric
Removing Dust and Flattening Fibers
This process is to print on fabrics clearly. The optional finisher
is used.
•
As the A4 standard tray, A5 tray, and Sleeve & Socks Tray becomes
hot when continuously used on the optional finisher, give an interval
of five minutes or longer to set them after they are pulled out.
•
Do not print on wet fabric. Doing so may result in a blurry image.
•
Do not use the spray. If you wet the T-shirt with the spray, the color
of the tray may stain the back of the T-shirt.
•
In high temperature environments, fabric might absorb moisture and
stretch after smoothed. Print immediately after loading the fabric.
•
Remove dust and lint from fabric before printing because dust and
lint whose color is the same with the fabric color are hard to find, we
recommend using a lint roller to remove dust and lint from fabric be-
fore smoothing it.
Remove dust and lint from the print surface of the fabric.
Remove them with a brush for clothes or a roller.
Use the finisher to flatten fibers and remove wrinkles.
•
When using the finisher, you can carry out heat press processing for
the fabric being loaded in the A4 standard tray, A5 tray, or Sleeve &
Socks Tray.
2
9