XYZ Printing Nobel 1.0A Quick Start Manual

ENGLISH
Quick Start Guide
Unpacking
①Upon receiving your printer, remove
the packaging materials, plastic bag,
tapes, and the accessory tray, and
assemble the lid by following the
instruction in the box. Then, remove
the protective foam from under the
platform according to the procedure
below:
(Bottom of the printer)
②Lay down the printer, and release
the printing module lock by pushing it
to the right. Follow the procedures to
remove the protecting foam under
the platform.
③Connect the printer to a power
source and turn on the printer. (Please
do not use the power adapter for
Nobel 1.0 on this model.)
④Select "UTILITIES" > "MOVE
PLATFORM">"TO TOP">"YES"
to raise the platform.
⑤Remove the protective foam.
*Keep original packaging material in the
event of sending your unit back for repair.
(US) XYZprinting, Inc.
Online Customer Service Desk: http://support.xyzprinting.com/us_en/Help/ticket/home
Welcome to your Nobel 1.0A Please read this guide carefully for tips on unpacking,
setting up, printing, and post processing to ensure an excellent 3D printing experi-
ence!
Product Overview & Accessories
Nobel 1.0A is shipped with the following parts and accessories. After unpacking,
please inspect the interior and exterior of the printer and accessories for damage.
Please contact support for any missing or defective parts and accessories.
Quick Start Guide
Warranty
Card
Power Adapter
Setting Up
Install and prepare the following parts before printing:
①Install the resin tank by pushing
the tank all the way into its slot.
②Calibrate the platform by selecting
"UTILITIES" > " HORIZON CALIB" and
follow the instructions on the screen.
After removing prints from the
platform, loosen 4 small screws over
the platform. And press OK and wait
until the platform has descended.
③Press the
platform with
both hands 3
times. Make sure
you see the right
side of the tank
sinks into the tank slot slightly. Free
you hands from the platform for a few
seconds so the silicon finish on the
tank can reshape. Check the tank frame
has repositioned (there's no gap
between the black frame holders).
Address: 9877 Waples Street, San Diego, CA 92121
Platform
Filling Tubes
Cartridge Slot
Tank Slot
Operation Panel
Nozzle cap
Power Cable
Inner Tube
USB Flash Drive
Website: http://us.xyzprinting.com
(Back View)
Lid
USB Drive Port Power Jack
USB Wire Port
Resin Tank
Rinse Basket
Starter Resin
USB Wire
Scraper
B2
④Place both
hands over the
platform to make
F2
sure the surface is
adhered to the
resin tanks. At the
same time, tighten
the fronts crews (F1, F2) with fingers
and then the screws at the back (B1,
B2). And then release both hands from
the platform, fasten the 4 screws firmly.
⑤Tighten the
B2
screws with a coin
or other tools
F2
(sequence from
F1, B1, F2 to B2)
and press [OK] to
complete calibration.
⑥Shake the resin cartridge for about
10 seconds.
⑦Assemble the nozzle cap and the
inner tube, and replace the bottle
cap with the assembled nozzle cap.
Power
Switch
Gloves
B1
F1
B1
F1
-1-