Table of Contents
Advertisement
-
Use the BEC when servo current consumption exceeds the current that supplied by ESC.
-
(Warning – Please following this procedures whenever put the power to the transceiver system.
-
Power ON: Power on the Tx first then power on the Rx next.
-
Power OFF: Power off the Rx first then power off the Tx next.)
Pre-flight checks
Please put the power to follow above warning order before use the engine or motor. And flight after check that all servos operate smoothly.
Range Check
Please check the range for verifying that transceiver operate normally.
(Warning – Transceiver Pre-set the ID for user's convenience when it comes from factory. Please follow the procedure below if you extra purchase
OPTIMA Rx due to additional planes.)
How to connect transceivers (ID setting) and set methods
Advertisement
Table of Contents
Need help?
Do you have a question about the FLASH 7 and is the answer not in the manual?