Solid-State Drive Holder And Board - HP 17g Maintenance And Service Manual

Solid-state drive holder and board

Description
Solid-state drive holder
Solid-state drive board
Before removing the solid-state drive holder and board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
7. Remove the solid-state drive (see
To remove the solid-state drive holder and board:
1. Remove the Phillips PM2.0×4.5 screw (1) that secures the solid-state drive holder to the computer.
2. Pull the board away from the connector on system board, and then remove the solid-state drive holder
and board assembly (2).
3. To remove the solid-state drive board from the holder, remove the two Phillips PM2.0×4.0 screws (1)
that secure the board to the holder.
Battery on page 32).
Optical drive on page
Bottom cover on page
Solid-state drive on page
34).
41).
50).
Component replacement procedures
Spare part number
858260-001
856614-001
51