Setting Up The 8800-2-4B (Ethernet Add-On); Figure 18 - Nport Configuration - Geokon 8800-2-1A Instruction Manual

18

5.2.2 Setting up the 8800-2-4B (Ethernet Add-on)

The MOXA 5110A will be setup by Geokon to communicate with a GeoNet Network
Supervisor, however, the end user will need to finish the setup so that it works with their
network. Configure an IP address by following the instructions below. (Note: The
following steps should only be performed by your network administrator. Nport
administrator (on cd) should be installed and used to configure the required IP
changes.)
1) Connect a computer to the MOXA 5110A via the Ethernet Port.
2) Open NPort Administrator and click "Search". (By default, the MOXA 5110A IP
Address "192.168.127.254" will be displayed.)
3) Double click on the IP Address under the configuration window.
4) In the configuration window, click on the Network tab.
5) Check the boxes next to "Modify IP address" and "Modify Netmask", see Figure 18.
Figure 18 – Nport Configuration