Battery Installation; Figure 8 - Battery Selects; Figure 9 - Battery Detail - Geokon 8800-2-1A Instruction Manual

6

2.5 Battery Installation

Install the D cells in the Supervisor first, followed by the Nodes.
Install the batteries as follows:
1) Open the device by unscrewing the four captive screws on the front of the enclosure. Make
sure that no dirt, water or other contaminants are allowed to enter the enclosure.
2) Prior to installing the D cells, ensure that the battery select switch is set to the "OFF" position
(Figure 8). (For units manufactured prior to June 2017, move the battery select switch to the
OPPOSITE setting of the type of battery that will be installed.)
3) Install the batteries by aligning the positive (+) side of the D cells with the left side of the
battery holder. Push the batteries straight down into the holder.
4) Move the battery select switch to either the "Alkaline" or "Lithium" position depending on
the type of battery being used.
5) An LED will flash on the right side of the box indicating the unit has power.
Figure 8 - Battery Select Switch

Figure 9 - Battery Detail