Node Tables; Table 23 - System Info Ands; Table 24 - Node Table Detail; D.6 Node Table - Geokon 8800-2-1A Instruction Manual

30
Address (hex)
0xE00
0xE01
0xE02
0xE09
0xE0A
0xE0B
0xE0C
0xE0D
0xE0E
0xE0F
0xE11
0xE11
0xE12
0xE13
0xE14
0xE15
0xE16
0xE17
D.6 Node Tables
Every Node that successfully joins the network will be represented in the Node tables that begin
at 0xE7D. There are 100 tables, each with 20 registers. There will never be any gaps in the table.
This is done so that the master device may build a list of Nodes by reading the tables until an
unpopulated table is encountered. An empty Node will have a serial number of zero.
R/W
R Firmware Version
R Hardware Version
R Debug Version
R Configuration
R Alarm Minutes
R Minutes
R Temp Command Code
R Channel
R RTC Calibration
R Serial Number LSW
R Serial Number MSW
R/W Modbus Timeout (seconds)
R/W Scan Rate (minutes)
R/W Time Zone Offset Minutes
R/W Seconds / Minutes
R/W Hour / Day
R/W Month / Year
R/W* Address MSW (only used on reads)
Table 23 - System Info and Settings

Table 24 - Node Table Detail

Data
uint8_t/uint8_t
uint8_t/uint8_t
uint8_t/uint8_t
Type
uint16_t
uint16_t
uint16_t
bitfield
uint16_t
uint16_t
NA
uint16_t
uint16_t
uint32_t
uint16_t
uint16_t
int16_t
uint16_t