Node; Figure 11 - Button Logic - Geokon 8800-2-1A Instruction Manual

9
Changes initiated by the status button will be made on the following radio cycle. This
could take up to three minutes when switching from normal mode to deployment mode,
as changes to the radio settings can only occur when all the radios in the network are
awake.
If the user presses the status button multiple times, the mode of operation will be
whatever is indicated by the final LED flash.
Figure 11 - Button Logic (Supervisor)

2.8.3 Node

If the green LED flashes on a Node when the status button is pressed, it will begin
indicating the status of the radio signal by flashing the LEDs during radio activity. If the
Node has not yet joined the network, it will also change its radio interval to
approximately one second.
If the red LED flashes when the status button is pressed, radio status indicating has been
disabled; no lights will flash thereafter.