Cellular Base Station Voice Guidance
Your Base Station has voice announcements. Select announcements are listed below:
Event
The Cellular Base
Station is powered on
Both red Emergency
and blue Reset Buttons
are flashing
The battery needs
charging
The Emergency call is
initiated
Call connected
Cellular Base Station
receives a Fall Signal
Fall Alarm is canceled
MHP8003-179E
MobileHelp Complete User Guide
CBS4.0_Complete_UserGuide_MHP8003-179E_12mech.indd 19
Voice Prompt
Base Station ON/OFF switch has been turned on, be sure to
"System Ready"
"Power not detected" or
"Power detected" (when
electricity is reconnected)
Check that the Base Station is correctly plugged into an
"Low Battery"
"Call in progress"
Alarm is being sent to the Emergency Response Center.
"Please stand by for
operator"
This will occur for about 20 seconds and will allow you time to
"Fall Detected - Press and
cancel the alarm. During this time, you may press and hold the
hold Button to Cancel"
button on the Fall Button for 5 seconds to cancel the signal.
"Alarm Canceled"
Notes
connect to electric outlet or it will run on battery backup.
Check that the Base Station is correctly plugged
into an electrical outlet.
electrical outlet or it will run on battery backup.
Respond to the Emergency Operator's call over
the device speaker.
Alarm has been canceled.
19
8/16/2018 11:14:13 AM
Need help?
Do you have a question about the Cellular Duo System and is the answer not in the manual?