Table of Contents
Advertisement
cHaPter 3
Controls
Focus Control
Magnification
Control
Specifications
12
FBP Probe microscope
The basic design of the Westover FBP probe microscope incorporates an imaging
system, integrated light source, video camera, focus mechanism and magnification
control. The probe is fully assembled and is powered by the display device. The only
assembly required by the user is the connection to the display device and installation
of the appropriate barrel assembly and/or the inspection tip. The FBP analog probe is
equipped with a 4-pin circular Hirose™ connector with notch-keys, which allows for a
secure and firm latch-lock connection to the display device.
inspection tip
Barrel Assembly
The focus control on the probe allows the user to adjust focus manually of the live fiber
end face image on the display.
The magnification control (available only on dual-magnification probes) allows the user to
switch between LOW and HIGH magnifications of the fiber end face image.
Dimensions
Weight
optical magnification
Focus control
cord length
connector
camera type
Video output
light source
lighting technique
Power source
User ManUal
Focus Control
140 x 46 x 43 mm (5.5 x 1.8 x 1.7 in)
180 g (6.3 oz)
200X, 400X, 200/400X
adjustable, in-probe
240 cm (94-in)
4-pin Hirose™ male
1/3-in cmos sensor
ntsc or PaL
Blue LEd, 100,000+ hour life
coaxial
From the display device or UsB module
Magnification Control
(Dual-mag probes only)
Advertisement
Table of Contents
