Draw Line By Position; Erase Line - Hondex HDX-121 Operation Manual

DRAW LINE BY POSITION

Lat/Long Input Box
SET key
3
Use NUMBER key to input lat/long. Use DIRECTION key (left/right) to
go back to the pre-set wrong value for correction if needed.
Press SET key to save the starting point. Input lat/long of the end
point with same method. Repeat the steps above to add more lines.
Note) "min" format is used for below "decimal point".
Divide "sec" lat/long with "60" (sexagesimal system) to convert
"sec" to "min".
e.g.) 10" (sec) = .167' (min)
30" (sec) = .500' (min)
135°35' 30"

ERASE LINE

Erase by Color
SET key
Erase All
SET key
1
Go to 8.OTHERS – 1.DRAW LINE –
5.DRAW MODE. Select POSITION.
2
Press SET key to start drawing. Lat/Long
input box appears on upper left of screen.
.135°35.500'
1
Go to 8.OTHERS – 1.DRAW LINE –
4.ERASE LINE – 1.ERASE BY COLOR.
2
Select a color.
3
Press SET key to erase the lines of
selected colors.
1
Go to 8.OTHERS – 1.DRAW LINE –
4.ERASE LINE – 2.ERASE ALL.
2
Press SET key to erase all lines.
52