NEC MultiSync P243W User Manual page 8

3. Height adjustment is locked by a lock switch. Place a hand on top of the stand and push the screen down to the lowest
position. Slide the lock switch to unlock the stand (Figure B.1).
NOTE: Handle with care when unlocking the stand.
Place your hands on each side of the monitor screen, tilt it to the maximum angle then lift it to the highest position
(Figure B.2).
CAUTION: The cable holder cannot be removed.
Figure B.1
4. Connect all cables to the appropriate connectors (Figure C.1). When using a USB cable, connect the B type connector
to the USB upstream port on the rear side of the monitor and the A type connector to the downstream port on the computer
(Figure C.1a). If using the cord from a USB device, plug it into one of the downstream ports of the monitor.
NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of the LCD panel
and/or shorten the module's life.
NOTE: Adjustment of the volume control as well as the equalizer to other settings than the center position may increase the
ear-/headphones output voltage and therefore the sound pressure level.
Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor lowers the sound.
CAUTION: Do not bind the USB cable. It may trap heat and start a fire.
USB downstream
(USB Type-A)
USB downstream (USB Type-A)
USB upstream (USB Type-B)
DVI-D
CAUTION: Do not connect headphones to the monitor while you are wearing them.
Depending on the volume level, it may damage your ears and cause loss of hearing.
Maximum Tilt
Highest Stand
Position
DisplayPort Audio Input
HDMI D-SUB Headphone
Power cord
Figure C.1
Cable holder
A Type
English-6
Maximum Tilt
Figure B.2
A Type
B Type
B Type
Figure C.1a